bukijin
Member
I have a Lee Classic Turret Press which comes with a 4 hole turret. Up to now, I have been using it as a single stage press by removing the indexing rod until I built up confidence in reloading. Now I want to use it as a progressive press to reload pistol calibres however I only have the 3 die sets not the 4 die sets.
If I bought a 3 hole turret would it fit into the press ? Or should I buy a factory pistol crimp die to put in the fourth hole and simply use my third die for bullet seating? Or can I just put the indexing arm back in and use it as a progressive press with only 3 dies in the four hole turret ?
I have been using the hand held auto prime for priming which works really well. Does anyone prime simply by using the Lee Lever Primer System ? Or should I buy the Lee Safety Prime for the press ?
Thanks in advance for your help...
If I bought a 3 hole turret would it fit into the press ? Or should I buy a factory pistol crimp die to put in the fourth hole and simply use my third die for bullet seating? Or can I just put the indexing arm back in and use it as a progressive press with only 3 dies in the four hole turret ?
I have been using the hand held auto prime for priming which works really well. Does anyone prime simply by using the Lee Lever Primer System ? Or should I buy the Lee Safety Prime for the press ?
Thanks in advance for your help...