Just arrvied is my new XCR. I bought YHM Irons sights from Tel-ton. I noticed when I placed the sights on the rail, there was some slight play in both front and rear . Is this normal? I have not shot the gun yet but it cannt be good when it starts woobling around. Have you guys noticed that on other BUIS? Thanks!
A little play in my YHM sights
- Thread starter Lou1187
- Start date
- Status
ARperson
Member
The YHM we have on our ARs fit very tight, with no wobble at all.
I did have wobble on a pair of very cheap scope mounts once. If it wobbles, I doubt your accuracy can be that good. If you have any, I would try a few other items to put on the rail to see if the YHM was machined too large or the rail is too small.
I did have wobble on a pair of very cheap scope mounts once. If it wobbles, I doubt your accuracy can be that good. If you have any, I would try a few other items to put on the rail to see if the YHM was machined too large or the rail is too small.
I wonder if your Yankee hills are set up for a Weaver rail and the XCR uses a Picatinney or 'English slot' dimension rail.
There are slight differences and this may account for the wobble.
Contact Yankee Hill and ask them if there is a solution.
http://www.yankeehillmachine.com
There are slight differences and this may account for the wobble.
Contact Yankee Hill and ask them if there is a solution.
http://www.yankeehillmachine.com
Lucky
Member
Wonder if you got the packaging with those sights, to make sure they're not Chinese airsoft knock-offs. In any case you should get them replaced, Yankee Hill stuff isn't cheap, so anything under the brand should be better than that.
- Status
