Quantcast
  1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

AMD-63 Build by AK-USA

Discussion in 'Rifle Country' started by MAUSER88, Dec 5, 2006.

Thread Status:
Not open for further replies.
  1. MAUSER88

    MAUSER88 Member

    Joined:
    Apr 16, 2004
    Messages:
    664
    Location:
    NJ
    Bought this kit from CFS a few years ago when they first came into the country. Kit was near mint and of course matching. I sent the wood to z_recto for refinish. As you can see he did a fantastic job. Chris at AK-USA ( www.ak-103.com ) said it was the nicest kit he had ever seen. It's built on a fully heat treated OOW receiver. Chris did his usual surperb job on the build. The finish is an enamel coating that holds up very well and gives the look of the original finish. Enjoy the pics of a AK you don't see very often.



    [​IMG]
     

    Attached Files:

  2. Simonovfan

    Simonovfan Member

    Joined:
    Nov 13, 2006
    Messages:
    50
    Nice looking rifle. The AMD's are pretty cool. I like the 65's as well. They look mean with the gas tube uncovered. I'm curious, does the vertical foregrip detach at all?.
     
  3. Will Learn

    Will Learn Member

    Joined:
    May 7, 2006
    Messages:
    481
    I just picked up a 103 from Chris a couple of months ago and am very happy with it.
     
  4. Gordon

    Gordon Member

    Joined:
    Dec 26, 2002
    Messages:
    8,292
    Location:
    central Kali.
    I finally detached (unscrewed the thru bolt) the foregrip after whittling it back so much it was a toothpick. Seems you can't 'speedload' by knocking the empty 30 round mag out reliably with the AMD 63 fore grip, cool looking though it is.....:uhoh:
     
  5. MAUSER88

    MAUSER88 Member

    Joined:
    Apr 16, 2004
    Messages:
    664
    Location:
    NJ
    Yes, I prefer to use the shorter 20 round mags with this AK.
     
Thread Status:
Not open for further replies.

Share This Page