I was asking earlier about the .358 molds and got good answers.
I'm getting ready to order the 358-125 to go along with my 358-200.
My wife wants me to order a mold for her 1911.
I'm leaning toward the 452-255 so I can cast for my muzzleloader also. It likes 250-300 grain bullets.
I did research and read of people using it. But they were back and forth about using a heavier recoil spring vs not using one.
Will using this bullet beat up a 1911 if it's loaded to eject the cases the same as factory ammo?
I usually load handguns for reliable function and stop well before max.
If it's a no go. I'll get the 200 SWC because that's what I load now.
I'm getting ready to order the 358-125 to go along with my 358-200.
My wife wants me to order a mold for her 1911.
I'm leaning toward the 452-255 so I can cast for my muzzleloader also. It likes 250-300 grain bullets.
I did research and read of people using it. But they were back and forth about using a heavier recoil spring vs not using one.
Will using this bullet beat up a 1911 if it's loaded to eject the cases the same as factory ammo?
I usually load handguns for reliable function and stop well before max.
If it's a no go. I'll get the 200 SWC because that's what I load now.