Glockdaddy
Member
A few weeks ago several of you shared some excellent information on smoothing the SP101 trigger. I have taken it apart twice....doing a polish job each time. The most recent was a very thorough polishing job as directed by instructions that were provide by BIGBOAR. And THANKS BB.....that info was GOLD!!
Here is my new question. I have smoothed the pull dramatically.....installed an 8# return spring and 12# Reduced hammer spring (both Wolff). But I still have a rough trigger return....not really scratchy....but it definitely returns in stages. And it actually makes a squeek noise..
This really won't have an effect on how the pistol shoots, but it does bug me and I am spoiled by some very sweet SW triggers.
So...can anybody refer me to the area of the trigger mechanism that I need to pay special attention to so that this return squeek and staging is reduced??? I would really appreciate it.
By the way, I did a good polish job on the trigger plunger and even put a bit of silicone lube there....because it looked like the possible cause.
I am sure gettin' good at tearing this little rascal apart!!
Thanks again guys......
GO STEELERS!!!
Here is my new question. I have smoothed the pull dramatically.....installed an 8# return spring and 12# Reduced hammer spring (both Wolff). But I still have a rough trigger return....not really scratchy....but it definitely returns in stages. And it actually makes a squeek noise..
This really won't have an effect on how the pistol shoots, but it does bug me and I am spoiled by some very sweet SW triggers.
So...can anybody refer me to the area of the trigger mechanism that I need to pay special attention to so that this return squeek and staging is reduced??? I would really appreciate it.
By the way, I did a good polish job on the trigger plunger and even put a bit of silicone lube there....because it looked like the possible cause.
I am sure gettin' good at tearing this little rascal apart!!
Thanks again guys......
GO STEELERS!!!