Try this: Using your press and case holder, place case holder in press, insert bullet case into case holder. Raise bullet up through the hole so the top of bullet is well above the top of the press. Use a small piece of wood resting on the top of the press. Rest a small pair of vice grip pliers adjusted just enough to get a bite on the bullet to be pulled. Rest the pliers on the wood, grip the bullet, then lower press handle. Pops then right off, does much less scarring of the bullet than you'd think. I built a jig that fits in the press that will raise pistol bullets up high enough. Much faster than the hammer, powder is still in the case, can pull about twenty, set in case holder, resize, then reload with another bullet.