Afetr discovering building a lower receiver from parts was a snap....I ordered a stripped upper and barrel kit from Del-Ton. I've been studying the assembly page on AR-15.Com on how to put it together. From what I can gather if the "barrel extension" (not a 100% sure I know what this is yet) is already on the barrel the headspacing shouldn't be an issue, just tighten the barrel nut and go. Is this the case here?
Also, is there a prescribed method for installing the A-2 flash hider to make it line up correctly, or just tighten until it's right? (is that why it's called a crush washer?)
While AR-15.Com is very informative I'm not yet a member over there and apparently cannot search for these answers, so any help or links would be appreciated.
Thanks
Also, is there a prescribed method for installing the A-2 flash hider to make it line up correctly, or just tighten until it's right? (is that why it's called a crush washer?)
While AR-15.Com is very informative I'm not yet a member over there and apparently cannot search for these answers, so any help or links would be appreciated.
Thanks