I have two ARs. One is a PWA and the other a factory colt. I just put on two sets of KNS anti walk anti rotate pins. In the PWA they seem to work fine. but I put the other set in the Colt and noticed that when I charged the bolt back it would lock up going forward. I had to pull the trigger and at the same time pull the bolt back and then release it with trigger pulled to get it to go into battery. I removed the pins and put back in the old set and the bolt worked fine again. The Colt is a 96 made with 800 rounds through it. I think the pins are a bit small for the colt and allow the hammer to rise just a bit to lock up the bolt. I put them in exactly like instructed with the anti rotate pin going into the hammer [the pin with ears]
The other problem I have is that I have four mags 20 rounds each a colt mag that over strips rounds on three mags. All of the problem mags are all plastic followers and all the mags are colt. The two with aluminum followers seem to work OK. Has anyone had this problem and is there a fix? The mags are good except for this. Is there a stronger spring that can make them work ok? Or maybe new followers?
The other problem I have is that I have four mags 20 rounds each a colt mag that over strips rounds on three mags. All of the problem mags are all plastic followers and all the mags are colt. The two with aluminum followers seem to work OK. Has anyone had this problem and is there a fix? The mags are good except for this. Is there a stronger spring that can make them work ok? Or maybe new followers?