I have several loads for 9mm. The FMJ's are from several different sources. The Cast Loads are data I have gathered, if Std Dev is shown, I have shot those loads and used my Chrony to collect data.
115gr, FMJ
3.9gr 700x, SPP, 991fps
3.7gr 700x, SPP, 1082
4.2gr 700x, SPP, 1091
4.3gr HP-38, SPP, 1079
3.3gr 700x, SPP, 986
5.1gr HP-38, SPP, 1167 (MAX Load)
4.7gr HP-38, SPP, 1075
5.0gr Unique, SPP, 1140
6.3gr Unique, CCI-500, 1244
4.5gr 700x, SPP, 1081 - 3" Barrel
4.5gr 700x, SPP, 1137 - 4 1/2" Barrel
4.4gr Bullseye, SPP, 1164, COAL: 1.140 - 1.145, Std Dev 26fps
4.7gr Bullseye, CCI-500, 1144
3.7gr Titegroup, SPP, 950, Light Load
7.0gr Bluedot, SPP, 1091, June 2016 Gun's Magazine
8.0gr, Bluedot, CCI-SMP, 1190,
5.4gr American Select, CCI-500, 1102
8.5gr Bluedot, CCI-500, 1258
6.7gr Power Pistol, CCI-500, 1212
My rue of thumb is anything I deem to be "Fast", I use Gas Checks to ensure I don't get barrel leading.
My Cast Bullets are 124gr RN,
6.0gr Bluedot, cci-500, 951
3.6GR 700X, Fed SP, 850, Std Dev 44 Fps, Extreme Spread 128fps
3.2gr 700x, Fed SP, 816
131gr Cast HP
4.1gr, 231, Fed SP, 1133
2.5gr, 231, Fed SP, 990
3.7gr, 700x, Fed SP, 1080
3.2gr 700x, Fed SP, 927
6.5gr Bluedot, Fed SP, 1089
5.8gr, Bluedot, Fed SP, 969
All were 4" Barrels unless otherwise noted. COAL 1.100 to 1.125, so if you use any of these, you'll need to check yours for fit.
And it should go without saying, BUT... These loads need to be worked up to, start at a lower powder charge, and gradually work up until you get/see the results you are looking for. No liability is assumed, use at your own risk. Good Luck