Best NAA Super Companion price seen out there?

[Tallbald]

All the postings about fun with the NAA BP revolver by Busyhands and others got my wanna-wanna going. Saw on another forum somebody got one for $189 delivered, but I don't know if it was new or not. What's the best price you all are seeing on the Super Companion? Thanks all. Don

 

[Busyhands94]

Midwest Hunter's outlet has em' for pretty cheap. however they are a bit tough to deal with. my gun was on backorder and it was a month before i got it. however it's worth it for such a neat pistol!

 

[Tallbald]

Hi Busyhands94. Thanks for the info. I went ahead and ordered one through my local dealer here in Bowling Green, KY. $203. Getting the Super Companion 1 5/8 incher. I'll have to pay 6% tax, but that's not their fault. I just look at it as one way to support my local economy. I have plenty of Triple 7 and #11 CCI Mag caps. Hope that's a good combo. What I will be annoyed at though is getting .22 balls. Casting suggestions?? Thanks, Don.

 

[Busyhands94]

i made an aluminum mold for my bullets, but i find mine shoots better with the 30 grain bullets NAA sells. Remington #10s work awesome in mine, i HIGHLY recommend ordering 1000 from Cabelas, they ignite very well. here's a link to the ones that work best in mine:
http://www.cabelas.com/product/Shoo...BC%3BMMcat104792580;cat104701680;cat104511780

also i did a youtube review of mine, i made a rear sight and you can see it in my video!
http://www.youtube.com/watch?v=rYyDMZc6vPQ&feature=channel_video_title

enjoy!

 

[Tallbald]

Busyhands94 can you share with me your .22 mold info? Is it .224 or what? Is there a buckshot size that corresponds to the size I need for my Super Companion? I have 200 number 10. And 2000 number 11. Hmmm. Thanks, Don.

 

[Busyhands94]

i bored it out with a bit that was a tad larger than my cylinder. but, it's kinda crude and i don't use it much. but if you want to make you own bullets you might want to get one of these: http://www.midwayusa.com/viewProduct/?productNumber=538620

it might be too long though, if it is you could shorten the mold, re-tap the hole and attach the sprue plate. haven't tried it yet, but it's still something to consider. i might get one someday! for molding lead bullets for the Super companion you might lead up the bore if you shoot hot loads, but if you were to use lead that is a little harder you might have better luck.