BHPshooter
Member
Decided to bite the bullet with the new FN and remove the mag disconnect. The trigger pin came out without any issues (whew!) and now I'm having problems with the smaller pin in the trigger that holds the evil part itself.
Anyone have any tips?
I'm laying the trigger on a block of wood with a hole drilled in it for the pin to fall through, which is sitting on the concrete floor. I have tried my smallest punch and a small finishing nail to drive the pin, and I am tapping it with a Lyman gunsmithing hammer.
Is it a case of persistence? I don't want to bugger up the finish...
Wes
P.S. I'm driving the smaller pin out from the same direction as I did the larger trigger pin... is that correct?
Anyone have any tips?
I'm laying the trigger on a block of wood with a hole drilled in it for the pin to fall through, which is sitting on the concrete floor. I have tried my smallest punch and a small finishing nail to drive the pin, and I am tapping it with a Lyman gunsmithing hammer.
Is it a case of persistence? I don't want to bugger up the finish...
Wes
P.S. I'm driving the smaller pin out from the same direction as I did the larger trigger pin... is that correct?