Quantcast
  1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

Broken 39-2 follower replacement?

Discussion in 'Handguns: Autoloaders' started by Gary O, Jan 1, 2008.

Thread Status:
Not open for further replies.
  1. Gary O

    Gary O Member

    Joined:
    Dec 15, 2003
    Messages:
    368
    Location:
    Roseville, CA
    I have a S&W Model 39-2 with a broken plastic magazine follower. Any ideas about possible replacement sources or possabilites? What say you? Thanks...
     
  2. The Lone Haranguer

    The Lone Haranguer Member

    Joined:
    Jul 30, 2006
    Messages:
    11,717
    Location:
    Johnson City, TN
    I looked at Numrich but did not find just a magazine follower. A little more thorough search than I did might turn it up.

    Midway shows factory magazines for Third Generation (39XX) pistols as also fitting the older 39s. (They also have ProMags but I don't trust this brand.) Might be time for an upgrade. :cool:
     
  3. wally

    wally Member

    Joined:
    Jan 2, 2004
    Messages:
    12,358
    Location:
    Houston, Tx
    Have you tried gluing the pieces back together? If the broken piece is lost, try building it up with JB Weld. I've had good success fixing mags that stopped locking back with a little JB Weld epoxy and some filing to fit.

    --wally.
     
Thread Status:
Not open for further replies.

Share This Page