Browning 2000 plug removal question

[ZBill]

I want to remove the plug that reduces the shell capacity of a Browning 2000. I downloaded the manual and the directions call for using 2 emply shell cases and removal via the breech. I don't have any empty cases on hand.

Is there a way to remove the plug from the front of the mag tube where the recoil system is located?

Thanks for any assistance. Bill

 

[rcmodel]

You should be able to completely dissemble the gas system.
Then drive out the cross-pin that holds the mag spring in.
(Be sure and control the spring, or it will fly out and shoot your eye out.)

Then pull out the spring & follower and take the plug out.

But it would be a lot simpler doing it the way Browning says, using two empty hulls to push the follower in past the two-shot plug and get it started out where you can come to grips with it.

Or a couple of chunks of 1/2" PVC pipe, or a couple of rolled up & taped cardboard tubes, or something?

Or shoot it twice and pick up your empties this time?

rc

 

[ZBill]

Thanks rcmodel

I will fashion something per your suggestions. And I appreciate the humor - I needed some just now. Regards, Bill