nitetrane98
Member
I've got a Challenger II and a III. The extractor on the II has a little chip off the bottom and is starting to exhibit some extraction problems. The chamber has to be imaculate to have reliable extraction these days where it used to shoot all day with anything you fed it, dirty, clean, it didn't matter.
My question is, does anybody know if the Buckmark extractor is the same as the earlier Challengers? I can see that the III is the same as the II. I've found the Buckmark extractor, spring plunger and spring at Midway for about 15 bucks. Nobody seems to have any specific II or III parts left.
Seems unlikely Browning would attempt to re-invent the wheel and re-design the extractor when everything is done to cut costs these days.
I might just go ahead and order it from Midway. I've wasted money on considerably less before, but still.....
Does anybody know for sure?
My question is, does anybody know if the Buckmark extractor is the same as the earlier Challengers? I can see that the III is the same as the II. I've found the Buckmark extractor, spring plunger and spring at Midway for about 15 bucks. Nobody seems to have any specific II or III parts left.
Seems unlikely Browning would attempt to re-invent the wheel and re-design the extractor when everything is done to cut costs these days.
I might just go ahead and order it from Midway. I've wasted money on considerably less before, but still.....
Does anybody know for sure?