higgite
Member
- Joined
- Dec 17, 2009
- Messages
- 2,087
It could be done, but you would have to modify either the die OD or the Bully adapter ID. The knurled top of the die body (right under the spring clip) is just a hair over 1” OD. The Bully adapter ID is just a hair over 0.9". You would need to replace the spring with something like a circlip that the Bully could slip over. You would also need to shorten the Bully so it wouldn't bottom out. You might also have to sleeve the upper portion of the Bully's bullet path to keep bullets from hanging up on the top of the die.Higgite, one question: What is the diameter of the M.B.F. die? Thinking of course, of the possible use of it with the Bully Adaptor!
I chose to make a simple aluminum adapter to mate the Lee bouquet of tubes to the Mr. Bulletfeeder die. Similar to the wiederladerTV adapter on Youtube, but sized for a snug slip fit over the MBF die's inner cylinder. No clamp required.