Texas Gun Person
Member
I ordered one of the little belt clip attachments for my Kel-Tec P32. Installing it requires the removal of the rear pin in the gun. However, this pin won't come out, or even budge. I actually bent one metal punch trying to get it out, and another punch is just burrowing into the pin rather than pushing it. A bigger pin just doesn't do anything. I have made several attemps and gone past being nice with the gun. I have applied CLP as a hopeful lube with also no luck.
Any advice?
Edit:
Kel-Tec gave me an answer.
Any advice?
Edit:
Kel-Tec gave me an answer.
Sometimes with time and heat the poly frame pins can wedge in there pretty good. We use a very small drill bit to drill a hole directly through the middle of the frame pin, then the punch will take it right out. be sure not to remove the hammer block pin though. It’s the metal one.
Last edited: