Ok, i was full length sizing some .308 federal brass i had sitting around and one got stuck in the die. I lubed and had already finished two batches, i was almost done with the third and had no other problems. The case went in O.K. like the others, but when i went to pull it out, the shell holder ripped two chunks off the rim. I tried to twist the shell holder and make it hold onto a different part of the rim, but it just pulled two more chunks off. So i cut and hacked away at the bottom and got my pin out of it. But now i am stuck with a die and most of a case in it. Any ideas on how i can get that out? I am using a lee classic turrett press with lee pace setter dies. Hornady one shot spray lube.