elChupacabra!
member
- Joined
- May 29, 2008
- Messages
- 562
Hey everybody, I recently got an inexpensive Savage Model 64 .22LR rifle and mounted a scope on it for plinking at the range. My problem is that the stock has a relatively low drop at the comb, and I would like to add some height so I can get a good cheek weld in line with the scope. I know there are several aftermarket cheek rests available, like these -
http://www.midwayusa.com/eproductpage.exe/showproduct?saleitemid=180913&t=11082005
http://www.midwayusa.com/eproductpage.exe/showproduct?saleitemid=129354&t=11082005
but it's hard to tell if they work well for a leftie, or are only designed for a right-handed shooter.
Can you help me with some suggestions as to which product I should check out, or - even better - does anyone have a "recipe" for creating something similar myself? I suppose I could work something up with duct tape and foam padding... does anyone have any experience here, or recommendations?
Thanks guys!
http://www.midwayusa.com/eproductpage.exe/showproduct?saleitemid=180913&t=11082005
http://www.midwayusa.com/eproductpage.exe/showproduct?saleitemid=129354&t=11082005
but it's hard to tell if they work well for a leftie, or are only designed for a right-handed shooter.
Can you help me with some suggestions as to which product I should check out, or - even better - does anyone have a "recipe" for creating something similar myself? I suppose I could work something up with duct tape and foam padding... does anyone have any experience here, or recommendations?
Thanks guys!