I'm going through that decision process, it's difficult to find a custom tactical commander in 10mm.
Hopefully by summer it'll be delivered and after a rigorous 1,000 round break in test, become a daily carry at my place. It will look something like this;
Overview;
1911 custom Fusion T-Comm Pro Series Elite 10mm, Black Shield frame/slide, stainless small accent parts.
Fine rear slide serrations
Top slide diamondline serrations
10-8 rear sight, tritium Trijicon front sight
Browning Hi-Power press check slide cut
Trigger job 3.75-4.25lb clean let off
Pro Series commander hammer, silver
Pro Series K trigger, silver, light adj
416 stainless match grade, commander ramped 10mm barrel with fitted link
Barrel flush cut and target crown
Thick flange chamfered bushing
High ride beavertail
Magwell stainless mainspring housing, chain link
Chain link front strap
Extended tactical thumb safety
Serrated slide stop, forged sure lock
GI guide rod system
Slightly extended combat mag release checkered
C'sink frame and flush cut slide stop pin
AAA+ Cocobolo white Ranger grip, my choice at end of build
Polish sides of slide - apply Black Shield coat
Brush polish small accent parts
Radius dehorn all edges for carry
Extra spring kit for set up
4 additional magazines
This should make for a nice IWB carry while working at my place, town carry, in the saddle or on the tractor. Those 200gr WFNs are equilizers for anything we have in these parts, including an increase in hog activity.