GENTLEMAN OF THE CHARCOAL
Member.
- Joined
- Jan 9, 2008
- Messages
- 1,632
REMOVAL AND INSTALLATION OF BOLT ASSEMBLY FROM THE RECEIVER.
1-Cycle the bolt handle to the open and back position. Then press down on the bolt handle.
2-Maintaining downward pressure on the bolt handle, pull the bolt assembly rearward. The entire bolt assembly will now pull free from the receiver.
INSTALLATION OF BOLT. (NOTE! BOLT MUST BE COCKED FOR INSTALLATION BACK INTO RECEIVER)
1-With the bolt assembly in the cocked position, align the bolt assembly in the same position as when removed. Using the thumb, push forward on the bolt cap, past the initial resistance, until the bolt assembly stops. Cycle the bolt handle up, then forward.
BOLT ACTION DISASSEMBLY/ASSEMBLY AND CLEANING.
1-CHECK TO INSURE GUN IS UNLOADED.
2-Using the Allen Wrench provided, unscrew the bolt cap by turning counterclockwise. The spring, striker, bolt handle, and bolt body will now come apart.
3-Clean all bolt parts thoroughly, dry all parts, then lubricate with non-petroleum based gun oil.
4-Reassemble bolt body, bolt handle, striker, and spring.
5-Move bolt to the uncocked position.
6-Place the bolt cap back over the spring. While pressing the spring downward, screw the bolt cap onto the bolt body.
7-Holding the bolt cap securely with the Allen Wrench, TWIST THE BOLT HANDLE COUNTER CLOCKWISE TO THE COCKED POSITION.
8-Return bolt to receiver as previously described....
1-Cycle the bolt handle to the open and back position. Then press down on the bolt handle.
2-Maintaining downward pressure on the bolt handle, pull the bolt assembly rearward. The entire bolt assembly will now pull free from the receiver.
INSTALLATION OF BOLT. (NOTE! BOLT MUST BE COCKED FOR INSTALLATION BACK INTO RECEIVER)
1-With the bolt assembly in the cocked position, align the bolt assembly in the same position as when removed. Using the thumb, push forward on the bolt cap, past the initial resistance, until the bolt assembly stops. Cycle the bolt handle up, then forward.
BOLT ACTION DISASSEMBLY/ASSEMBLY AND CLEANING.
1-CHECK TO INSURE GUN IS UNLOADED.
2-Using the Allen Wrench provided, unscrew the bolt cap by turning counterclockwise. The spring, striker, bolt handle, and bolt body will now come apart.
3-Clean all bolt parts thoroughly, dry all parts, then lubricate with non-petroleum based gun oil.
4-Reassemble bolt body, bolt handle, striker, and spring.
5-Move bolt to the uncocked position.
6-Place the bolt cap back over the spring. While pressing the spring downward, screw the bolt cap onto the bolt body.
7-Holding the bolt cap securely with the Allen Wrench, TWIST THE BOLT HANDLE COUNTER CLOCKWISE TO THE COCKED POSITION.
8-Return bolt to receiver as previously described....
Last edited: