The stem on my decapping/resizing die moved, so, I reset the stem to flush as described in the instructions
I Feels like it bottoms out on the primer pocket, and the stem wants to setup about 1/16 of an inch above flush
I snugged it up pretty good and it continues to move up that little bit on the first resize or it kind of feels like it is flexing the primer pocket if I lock it down so it cant move from flush.
Is there a better method for setting depth on the stem? i.e. snug it up but not so tight it cant move, run it into a case, let it self adjust, and then tighten? Or, measure how far the pin extends beyond the bottom of the die and set it at a specific depth?
Any help is always appreciated.
d
I Feels like it bottoms out on the primer pocket, and the stem wants to setup about 1/16 of an inch above flush
I snugged it up pretty good and it continues to move up that little bit on the first resize or it kind of feels like it is flexing the primer pocket if I lock it down so it cant move from flush.
Is there a better method for setting depth on the stem? i.e. snug it up but not so tight it cant move, run it into a case, let it self adjust, and then tighten? Or, measure how far the pin extends beyond the bottom of the die and set it at a specific depth?
Any help is always appreciated.
d