Thanks to some good advice (mostly from JackOfAllTradesMasterAtNone) from you guys, we went back into the Mark II. Here's what we did:
1, polished Transfer bar
2, polished inside of frame
3, polished sear, hammer and all friction points (after stoning)
4, cut about 1 1/2 coils out of the main spring
5, set up a jig, SLIGHTLY stoned hammer & sear
It feels lighter, more crisp/short and it's better for sure....
We were at 3 3/4 pounds, I need to go to the range to get the new trigger weight. I'll post it soooon.....
QUESTION: How does a lighter main spring weight help the trigger pull? I can't figure out how that works.
THANKS for the good advice!!!!!!!!!!!!!!
1, polished Transfer bar
2, polished inside of frame
3, polished sear, hammer and all friction points (after stoning)
4, cut about 1 1/2 coils out of the main spring
5, set up a jig, SLIGHTLY stoned hammer & sear
It feels lighter, more crisp/short and it's better for sure....
We were at 3 3/4 pounds, I need to go to the range to get the new trigger weight. I'll post it soooon.....
QUESTION: How does a lighter main spring weight help the trigger pull? I can't figure out how that works.
THANKS for the good advice!!!!!!!!!!!!!!
Last edited: