dillon primer tubes in rcbs bench mounted priming tool
- Thread starter larry7293
- Start date
- Status
Blue68f100
Member
Dillon uses plastic reducing tips on both ends of the Al tubing. So if the RCBS bench priming tool uses the std 1/4" dia tubes they will not work.
cheygriz
member
I've been using them for many years.
They make a good counter. Every time I refill 100 primers in the tube, I weight a powder charge.
They make a good counter. Every time I refill 100 primers in the tube, I weight a powder charge.
Blue68f100
Member
Not my experience with them. The plastic is weak and I've dumped primers all over the place when they decide to give up. Dillon replaced the plastic ends but I still don't trust them. I've also have the get held up in the are where they neck down.
billybob44
Contributing Member
Not correct..The Dillon Pick-up tubes have a plastic piece that picks up the primers on one end of the tube-The other end has hole for the Hair pin retainer that holds the primers.
To the OP's question--YES--you + I DO use Dillon pick up tubes in my RCBS Bench mounted primer--It's just a little longer than the RCBS tube..
Hondo 60
Member
Not to start a fight, but Blue68f100 is correct.
Dillon uses plastic tips on both ends.
Dillon uses plastic tips on both ends.
cheygriz
member
Used them for over 30 years and never had a problem of any kind.
Whiterook808
Member
They must must have changed the design over the years. I bought several Dillon tubes years ago and they do not have that plastic piece on the end with the pin. I guess it just depends on the vintage of your gear.
- Status
Similar threads
- Locked
