I'd like to raise my hornady LNL AP press right now its mounted to my reloading bench I built @ 36 inches. I stand when I reload and have been getting a sore back after an hour of bending over and pulling the handle.The eight inch height increase would be an improvement
But I guess the big question is will the bolt holes in the dillon strong mount line up with the LNL press? I could probably fabricate some steel plate and weld up something but justs seems like a less work to bolt on the dillon ?
But I guess the big question is will the bolt holes in the dillon strong mount line up with the LNL press? I could probably fabricate some steel plate and weld up something but justs seems like a less work to bolt on the dillon ?