1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

First shot at modding my AR

Discussion in 'Rifle Country' started by Boomie, Dec 23, 2011.

Thread Status:
Not open for further replies.
  1. Boomie

    Boomie Member

    Aug 24, 2010
    Years ago I bought a Rock River 16" Varminter. I had little experience with ARs and I thought it would be a good "do everything rifle". I had it topped with a 1-4 power Leupold and called it a day. I now know that a lighter, longer barrel would fit that role better but I didn't know then what I know now.

    What I did find out is that a 16" Varminter is a great rifle for carrying into the woods and hunting / eliminating small game (groundhogs, coyote, etc.). To this end it's Leupold was replaced with a 6-20 Vortex Viper scope on a Burris PEPR mount. To get this to work I also added a Badger charging handle. I also tried my hand at Duracoating mainly to cover the shine of the barrel, but also to break up the silhouette. That's how my rifle existed for a while longer (see pic).

    As I used it more I found I liked the 16" barrel but did not like the carbine length forend. Since this rifle always had a bipod on it there wasn't enough room to have both the bipod and a support hand for off-hand shooting. So I decided to try my hand at some AR gunsmithing and do something about it.

    I went ahead and replaced the carbine length forend with a Rock River rifle length one. It was a lot easier than I thought it would be. I stuck with the same basic type as I liked how it felt in my hand and I had no need for rails (but I did need a sling swivel). To get this to work I had to swap the gas block with a low profile one. While I was at it I swapped the trigger guard for a Magpul Enhanced one (since I do hunt with gloves) and got some K-N anti-rotation pins (just in case).

    I'm pretty happy with how it turned out. She's still a great shooter but, for me, the ergonomics have been greatly improved on.

    Attached Files:

  2. 68wj

    68wj Member

    May 2, 2010
    Look'n good.
Thread Status:
Not open for further replies.

Share This Page