Quantcast
  1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

Fitting a new #4 mk2 ejector

Discussion in 'Gunsmithing and Repairs' started by Fatelvis, May 5, 2003.

Thread Status:
Not open for further replies.
  1. Fatelvis

    Fatelvis Member

    Joined:
    Dec 25, 2002
    Messages:
    1,859
    Location:
    Lockport, IL
    My old one doesnt kick out the spent brass, it just stays in the receiver. I replaced the exractor spring (with a new one), but it didnt help. Is the ejector just worn down too short? Is it as simple as just ordering a new one and replacing the old one, or does it have to be fitted? If so, is it difficult? Thanx a million!
     
  2. Just get a new ejector screw and install it. It should not require fitting.
     
Thread Status:
Not open for further replies.

Share This Page