Fluted .45 Colt Bisley Blackhawk?

Status
Not open for further replies.

.455_Hunter

Member
Joined
May 25, 2005
Messages
5,069
Location
Colorado Front Range
Did Ruger ever make a run of the stainless Bisley Blackhawk in .45 Colt with a 5.5" barrel and fluted cylinder? If so, what was the product code? Thanks for your help!
 
All of the first Bisley models were produced with fluted cylinders because it took more time than Ruger expected to find a way to roll mark the cylinders so they just used the fluted cylinders on hand. I have a .41 Bisley that is fluted. Fluted Bisleys are kind of rare and usually bring a higher price. The 5.5 in. barrel sounds like a later version though, all that I have seen were 7.5 in. It's possible that someone installed the cylinder or changed the barrel after it left the factory. Ruger's website has a serial number - dating section.
 
I remember seeing a .22 Bisley with a fluted cylinder. I think it was a limited edition model as it had a blued frame and a polished stainless grip frame. Looked very tempting but I only had enough cash for one gun and they had a Mk.II bull barrel with the same two-tone look that I wanted more than the Bisley. Can't recall seeing any Bisleys in .45 with a fluted cylinder.
 
I agree with DRAIL, all early model Ruger Bisleys had fluted cylinders. I'm not sure about the barrel lengths available. Mine is, indeed, 7 1/2". I have to say that the fluting on the cylinder I have is less than perfect. I've never seen that on a Ruger before.
 
I have a pair of Bisley Blackhawk. 45 Colt/.45 ACP convertible revolvers with 5-1/2" barrels. The. 45 ACP cylinders are fluted.

bh_bisley_01.jpg
 
eldon519 said:
You could always convert a Blackhawk.
Yup. Wasn't inexpensive, but I did that to a 5.5" stainless Super Blackhawk in .44 mag.

attachment.php
 
Status
Not open for further replies.
Back
Top