Quantcast
  1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

g3 build?

Discussion in 'Rifle Country' started by AMerexican, Nov 12, 2009.

Thread Status:
Not open for further replies.
  1. AMerexican

    AMerexican Member

    Joined:
    Jul 24, 2009
    Messages:
    50
    Location:
    Mississippi
    ok i'm thinkin' bout buildin' a g3 an was just wonderin' what all would be required? i have found a receiver and trigger group along with the ever plentiful stock sets. i know i'm forgettin somethin though. any an all help would be appreciated. Thanks! :)
     
  2. Maverick223

    Maverick223 Member

    Joined:
    Dec 19, 2008
    Messages:
    11,269
    Location:
    28078
    Well...you might want a bolt group and a barrel to go with the other parts. :p Make sure that the trigger group is NOT a FA variant as there are multitudes out there that are, and the BATF is not too friendly about those sort of kits being built into unregistered rifles. I would look into a PTR-91 or even a CETME because I highly doubt that you can build one and come out ahead.

    Good luck, Mav.

    :)
     
  3. AMerexican

    AMerexican Member

    Joined:
    Jul 24, 2009
    Messages:
    50
    Location:
    Mississippi
    tahnks mav. i new it was somethin obvious :banghead:
    but i couldnt think of what it was. guess i had a blonde moment.
    an it's not really bout comin out ahead so much as makin a a few samll purchases instead of one big one. mostly to keep SWMBO happy. ya know? :cool:
     
  4. Avenger29

    Avenger29 Member

    Joined:
    Jun 2, 2005
    Messages:
    2,728
    Location:
    SC
    God made Lay-away and piggy banks for a reason...
     
  5. Maverick223

    Maverick223 Member

    Joined:
    Dec 19, 2008
    Messages:
    11,269
    Location:
    28078
    No problem, AM. I follow exactly, however I would save up for a CETME, or look for good deals on a PTR-91 (much better IMO). I think you will encounter fewer problems going this route. If you ultimately decide to build it yourself just make sure that the lower is NOT fully auto and that you properly headspace the bolt prior to test firing.

    :)
     
Thread Status:
Not open for further replies.

Share This Page