Red Tornado
Member
I recently bought a (very) used Remington Speedmaster 552. It shot fine, and cycled ammo with only one FTF in about 100 rounds. It showed a lot of carbon build and I cleaned it.
I downloaded the intruction from Remington's web site, and removed all of the build up, but now it won't cock the hammer when it cycles.
It cycles the round, and chambers the next round, but it's not cocked. I can cycle by hand, and it ejects the unfired cartridge, chambers the next one, and fires fine, but doesn't automatically cock the hammer.
Any suggestions? I'm a newbie, so it could be something very obvious. Any suggestions will be greatly appreciated.
TIA,
RT
I downloaded the intruction from Remington's web site, and removed all of the build up, but now it won't cock the hammer when it cycles.
It cycles the round, and chambers the next round, but it's not cocked. I can cycle by hand, and it ejects the unfired cartridge, chambers the next one, and fires fine, but doesn't automatically cock the hammer.
Any suggestions? I'm a newbie, so it could be something very obvious. Any suggestions will be greatly appreciated.
TIA,
RT