Okay I am a revolver man, not an autoloader kind of guy, but my friend has a p95 Decocker only, recent purchase, and we were messing around with it today. Feild stripping went fine, drop hammer, drop mag, rack back slide, push down decocker, let slide go forward until two - - marks align and you can remove slide lockback/slide release, keep on going forward and remove slide. Flip slide up, push back on spring shrouded guiderod an cam to allow it to go free from the notch on the back of the barrel, then lift out. Slide barrel back a little bit so you can angle it up a little and lift free.
Follow the same in reverse. Did it just fine a few times. One time we got sloppy, either because I let the slide slip on me, or he forgot to depress the ejector. Anyways the slide went forward when trying to get the slidelock back in, and upon reracking it, we couldn't get the slide quite far enough back to get the slide lock fully in, and of course, now the hammer is cocked and the ejector has been pushed back up or was up all along.
so the gun appears to look normal, except no slide lock, and 1 inch of barrel and guide rod are poking out the front.
with work I can wiggle the slidelock in, but that didn't help any
I can reach up with a bent wire and grab the ejector and pull it down into disassemble position, and then try and slide the barrel off, all I get is the following
umm...help?
Follow the same in reverse. Did it just fine a few times. One time we got sloppy, either because I let the slide slip on me, or he forgot to depress the ejector. Anyways the slide went forward when trying to get the slidelock back in, and upon reracking it, we couldn't get the slide quite far enough back to get the slide lock fully in, and of course, now the hammer is cocked and the ejector has been pushed back up or was up all along.
so the gun appears to look normal, except no slide lock, and 1 inch of barrel and guide rod are poking out the front.
with work I can wiggle the slidelock in, but that didn't help any
I can reach up with a bent wire and grab the ejector and pull it down into disassemble position, and then try and slide the barrel off, all I get is the following
umm...help?