Corpral_Agarn
Member
Hello THR!
I took the cylinder out of my Uberti Cattleman to clean it (essentially a SAA) and for whatever reason, after reassembled, when I cock the hammer (all the way back) the cylinder free spins for a bit then stops. that's not right. Also, when the hammer is cocked and the trigger is pulled, the hammer does not drop the first time and it looks like the cylinder is rotating just a touch the wrong way before it finally can drop.
It seems to me the bolt at the bottom of the frame is not popping up to stop the cylinder. Perhaps a lock timing issue?
I am not an expert on SAA's. Please, I need help. This is one of my favored pieces to carry while horseback. What is going wrong?
Thank you!
I found this Post: http://www.thehighroad.org/archive/index.php/t-536811.html
it might be the same. can someone confirm?
I took the cylinder out of my Uberti Cattleman to clean it (essentially a SAA) and for whatever reason, after reassembled, when I cock the hammer (all the way back) the cylinder free spins for a bit then stops. that's not right. Also, when the hammer is cocked and the trigger is pulled, the hammer does not drop the first time and it looks like the cylinder is rotating just a touch the wrong way before it finally can drop.
It seems to me the bolt at the bottom of the frame is not popping up to stop the cylinder. Perhaps a lock timing issue?
I am not an expert on SAA's. Please, I need help. This is one of my favored pieces to carry while horseback. What is going wrong?
Thank you!
I found this Post: http://www.thehighroad.org/archive/index.php/t-536811.html
it might be the same. can someone confirm?
Last edited: