I recently bought a Fero Z24 scope for my PTR. The scope is in very nice condition with clear optics but when it is mounted the reticle is canted a few degrees off from horizontal! I don't have any experience with these scopes but is there any way to correct this? It's not a huge deal I guess, but it looks kinda silly...
Hensoldt Fero Z24 question...
- Thread starter Wolfsburg
- Start date
- Status
rcmodel
Member in memoriam
Nope, I don't think so.
Most likely an out of spec receiver on your PTR.
I have seen comments about people having to take off the little plastic bumper pad that butts up against the rear sight to get them to set down & lock down right.
Might check that out.
rc
Most likely an out of spec receiver on your PTR.
I have seen comments about people having to take off the little plastic bumper pad that butts up against the rear sight to get them to set down & lock down right.
Might check that out.
rc
Last edited:
Well, a friend of mine looked at it and says it looks fine to him. Maybe I'm just getting cockeyed. I guess I need to put the gun in a mount and see how it looks then. I certainly hope the receiver isn't out of spec!
I know the bumper people are referring to, but I didn't have any problems getting the mount clamped down. It doesn't appear to be interfering with anything that I can tell.
I know the bumper people are referring to, but I didn't have any problems getting the mount clamped down. It doesn't appear to be interfering with anything that I can tell.
- Status
