I've been using my LNL for about a month now with the New Dimension dies, but I'm still running into two issues which are really slowing me down (I could probably run a single stage faster).
Here is how I have the dies set up (9mm at the moment):
Station 1 - Hornady Deprime/resize
Station 2 - Expander
Station 3 - Powder Drop
Station 4 - RCBS powder lockout
Station 5 - Seating/Crimp
First, the seating/crimp die is hitting the ejector wire so I'm ejecting by hand. I've read the the Lee dies do not work in station five without adjustments but shouldn't the Hornady dies? Am I not adjusting this station correctly?
Secondly, the bushings keep loosening on the powder drop. I'm going to give the extra o-ring suggestion a shot this weekend so hopefully this one will get work out. Any other suggestions?
Thanks,
mobiusnc
Here is how I have the dies set up (9mm at the moment):
Station 1 - Hornady Deprime/resize
Station 2 - Expander
Station 3 - Powder Drop
Station 4 - RCBS powder lockout
Station 5 - Seating/Crimp
First, the seating/crimp die is hitting the ejector wire so I'm ejecting by hand. I've read the the Lee dies do not work in station five without adjustments but shouldn't the Hornady dies? Am I not adjusting this station correctly?
Secondly, the bushings keep loosening on the powder drop. I'm going to give the extra o-ring suggestion a shot this weekend so hopefully this one will get work out. Any other suggestions?
Thanks,
mobiusnc