I know there are quite a few LnL users here - a couple have already been a great help.
I seem to be having a problem with the die bushings - they seem work loose after several rounds (I will normally see movement in my sizing die first) at which time I will give them a hand tightening tweak (I'm not Mr. T).
All will be well for the rest of the session, but when I try to remove the dies, one or two will invariably be so tight that I loose the die setting trying to get them out.
Is there a technique I'm not using ?
Buff with a dremel ?
Dab some lube around the bushing ?
None of the above ?
Getting tired of all my die sets having a note... "recheck M die"..."Redo bullet seater" etc.
This was one of the features that sold me on the AP, along with the 5th station.
Just to be clear - the dies are solid in the bushings - it's getting the bushings out of the press that is the problem.
Any help welcome.
I seem to be having a problem with the die bushings - they seem work loose after several rounds (I will normally see movement in my sizing die first) at which time I will give them a hand tightening tweak (I'm not Mr. T).
All will be well for the rest of the session, but when I try to remove the dies, one or two will invariably be so tight that I loose the die setting trying to get them out.
Is there a technique I'm not using ?
Buff with a dremel ?
Dab some lube around the bushing ?
None of the above ?
Getting tired of all my die sets having a note... "recheck M die"..."Redo bullet seater" etc.
This was one of the features that sold me on the AP, along with the 5th station.
Just to be clear - the dies are solid in the bushings - it's getting the bushings out of the press that is the problem.
Any help welcome.