marc82much
Member
Running 9mm now. When I the PTX expander installed in the powder drop and set to where it "bells" the amount I want, I lock it down then proceed to make sure the arm that measures then drops the charge goes all the up to the top of its arc.
When this is all set, that should be it (I guess) but when I run just 1 shell through, the dispensing arm of the powder drop goes up about 1/4 of it's normal movement just from the bottom of the mechanism hitting the (empty) shell plate. It does not seem to drop any powder at this point, but I am wondering if this is normal.
In Gavin's video showing the LNL running some 45ACP, his does it too, but mine seems to up up a little higher.
Is there an adjustment for this? Does it matter? As long as no powder drops out is it OK?
When this is all set, that should be it (I guess) but when I run just 1 shell through, the dispensing arm of the powder drop goes up about 1/4 of it's normal movement just from the bottom of the mechanism hitting the (empty) shell plate. It does not seem to drop any powder at this point, but I am wondering if this is normal.
In Gavin's video showing the LNL running some 45ACP, his does it too, but mine seems to up up a little higher.
Is there an adjustment for this? Does it matter? As long as no powder drops out is it OK?