The kit comes with a "female" bushing that screws into most single stage presses (the female bushing would NOT fit in a Dillon, or any other progressive or turret press that I can think of), like the Rock Chucker, Lee Classic Cast Press, older Pacific (Hornady) 07 or 007, Lyman single stage, etc. There are male bushings that you install on your dies, and you leave them on each one... after it's adjusted once, you just drop 'em in the mating bushing in the press and give them a 1/4 turn or so, and they lock in. Extra male bushings are pretty cheap, a 3 pack goes for around 10.00 or so online.
If you haven't bought a press yet, you can buy a single stage with this system pre-installed, the Hornady LnL classic... I just bought one, pretty hefty press. If you are looking at progressives, take a look at the Hornady LnL AP.