winfreeokra
Member
- Joined
- Mar 31, 2021
- Messages
- 80
Today while getting some rounds through my new CZ P-01 Omega on about the second clip the gun would suddenly not fire. Hard stop on the trigger just prior to break point. Upon inspection the decocking lever had walked out just a smidge. Essentially the amount required for the first step if you were removing it for conversion to a safety.
I snapped it back in place and fired another 140 rounds or so without issue. Hard for me to understand how it would have maybe not been fully seated to start. I’ve had it apart once just to learn the conversion but had shot a few hundred rounds since then.
I inspected it closely during cleaning and everything is correct and in place.
Fluke to keep an eye on or don’t carry until it proves itself?
Should add it’s new in the sense that I’ve only got about 500 rounds through it. Have had it a few months now and the only other thing done is that I had my local shop change the sights out.
Edit: Basically whats shown in the picture, which cant be done without depressing the ejector, which cant be done with the slide one so I had to of bumped it during the last cleaning.
I snapped it back in place and fired another 140 rounds or so without issue. Hard for me to understand how it would have maybe not been fully seated to start. I’ve had it apart once just to learn the conversion but had shot a few hundred rounds since then.
I inspected it closely during cleaning and everything is correct and in place.
Fluke to keep an eye on or don’t carry until it proves itself?
Should add it’s new in the sense that I’ve only got about 500 rounds through it. Have had it a few months now and the only other thing done is that I had my local shop change the sights out.
Edit: Basically whats shown in the picture, which cant be done without depressing the ejector, which cant be done with the slide one so I had to of bumped it during the last cleaning.
Last edited: