I just recieved my "Nitesiters", site enhansers

[gym]

I ordered the Nitesiters, from Midway USA, they are a cheapo way of putting nite sights on a weapon. I'll get back to you guys after I install them. They will be a cost effective way of putting Luminasent sights on a gun that you don't feel like spending a lot of cash on the gun, for a set of decent sights. I tried that glow paint, and it lights up real bright, but doesn't stay lit very long. This looked like a better product. I don't mind spending money on my more expensive weapons, but I hate putting $200.00 sights on a $300 dollar gun. Armalaser is making a $159.00 touch sensitive laser system for Keltec's Glocks and xd's. It looks like it is a decent quality for your cheaper guns, that may sit in the car, or stashed someplace in the house, as an emergency gun. I can't justify putting $3-400.00 laser sights on a half dozen guns.

 

[gym]

I installed them about an hour after I posted. Cleaned the sights well with the enclosed wipe, there is a little kit with a blade, toothpick cut flat on one side, alcohol wipe, and a cuetip. There are 8 dots enclosed. The idea is to remove them from the strip and using the enclosed blade and pick, to put each dot over the current dot on the existing site. It took about 15 minutes, to do all 3 dots on my PF9. I then used a hair dryer to heat the adhesive up and that''s it. I left the gun out on the table till after the UFC fight was over. It was litt up two hours later as I left it on top of the night table, that impressed me, as the "glow paint" only lasted 15 minutes tops. Now I'll take it to the range, to see if the suckers stay on under firing a few clips, otherwise, a dab of epoxy or crazy glue may be needed, but since they give you 8 dots, even if one or two goes MIA, it can be replaced.