Installtion On A Flat Msh

[lonewolf5347]

I had some one give me a Kimber flat MSH they no longer used
I did install it in the SA 1911 and found I hand problems trying to get the lower pin to exit the other side of the frame.
My easy fix was to open the exit side of the MSH a tad (on one side)now the pin goes threw the frame with no problems
Will I have Any Problem using the Kimber flat MSH

 

[rcmodel]

Sounds like either the frame or the housing is drilled crooked.

It should fit any 1911 frame if the holes are right in both.


rcmodel

 

[lonewolf5347]

I think the Kimber MSH was a tad off center my ARCHED MSH from SA lines up perfect
I did notice the Kimber a little tight also sliding into the frame
I just want to see how I would like the Flat MSH compared to my arched housing :I did try it in the frame seem I have better control as far as wrapping the hand around the frame handle grips;I have medium size hands and the thin grips make a world of difference