You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an alternative browser.
You should upgrade or use an alternative browser.
Internally Silenced 10/22
- Thread starter kennyboy
- Start date
- Status
-
Not open for further replies.
rangerruck
Member
i think two do it , maybe more, Advanced Armament corp., and Gemtech, both do it, you can buy theirs, or send them yours.
waterhouse
Member
http://www.paladinarmory.com/
http://www.trosusa.com/Rimfire/Ruger10-22.htm
Here are a few more. I think lots of places do it. If you are looking to keep the overall barrel length with the suppressor attached as short as possible (one reason to go internally suppressed) you might check out Tactcal Solutions barrel:
http://www.tacticalsol.com/store/pc/viewPrd.asp?idcategory=4&idproduct=711
It is a short barrel with a perm. attached "cage" that a suppressor can go in, so that your barrel is 16" whether you have the can attached or not.
http://www.trosusa.com/Rimfire/Ruger10-22.htm
Here are a few more. I think lots of places do it. If you are looking to keep the overall barrel length with the suppressor attached as short as possible (one reason to go internally suppressed) you might check out Tactcal Solutions barrel:
http://www.tacticalsol.com/store/pc/viewPrd.asp?idcategory=4&idproduct=711
It is a short barrel with a perm. attached "cage" that a suppressor can go in, so that your barrel is 16" whether you have the can attached or not.
kBob
Member
+1 waterhouse on Paladin Armory.
Bill, the owner is just getting his machinery up and running in Montana. He had been building in Florida, but was recalled to Active Duty a USAF officer a bit before 9-11 and only just allowed to retire this past year.
I have shot a couple of his dedicated suppressor 10/22s and was impressed.
I especially liked his own original low maintenance design dedicated suppressor system which I used on a 10/22 and on a little Marlin bolt action of some type. The system is simple beyound beleif and while I did not have any sort of sound meter available both guns with the low maintenance system were very hushed.
It would be difficult for a drunken monkey to bugger up his low maintenance system or install it improperly after cleaning.
Give him a look.
-Bob Hollingsworth
Bill, the owner is just getting his machinery up and running in Montana. He had been building in Florida, but was recalled to Active Duty a USAF officer a bit before 9-11 and only just allowed to retire this past year.
I have shot a couple of his dedicated suppressor 10/22s and was impressed.
I especially liked his own original low maintenance design dedicated suppressor system which I used on a 10/22 and on a little Marlin bolt action of some type. The system is simple beyound beleif and while I did not have any sort of sound meter available both guns with the low maintenance system were very hushed.
It would be difficult for a drunken monkey to bugger up his low maintenance system or install it improperly after cleaning.
Give him a look.
-Bob Hollingsworth
www.silencertests.com more info there from folks that know through experience
- Status
-
Not open for further replies.