ADKWOODSMAN
Member
Any luck finding Remington Rifle & Pistol brass out there. :banghead:
Is there new Remington brass out there?
- Thread starter ADKWOODSMAN
- Start date
- Status
Reloadron
Contributing Member
Rifle? Handgun? A caliber would help. However, Cabelas has some assorted 100 count pistol brass. They also have some 50 count rifle brass but it is off caliber like 375 H&H.
Ron
Ron
splattergun
Member
Saw some .45 and others at Sportsmans Warehouse. But I don't think they have a store in NY. Try their website.
Wreck-n-Crew
Member
At the price of Remington rifle brass it was cheaper for me to buy the ammo and procure my own once fired.
As far as pistol brass i never buy new unless its 10mm. And i have not ordered in year.
As far as pistol brass i never buy new unless its 10mm. And i have not ordered in year.
NeuseRvrRat
Member
I hate Remington pistol brass. It never has enough tension to hold a bullet properly.
627PCFan
Member
My guess is he's trying to match rims for moon clips
ADKWOODSMAN
Member
I am looking for 308, 7-MM-08 and 30RSAM for my hand loaded deer rounds.
Remington brass whether rifle or pistol I have used for over 40 years.
However most of my pistol brass now is starline.
Remington brass whether rifle or pistol I have used for over 40 years.
However most of my pistol brass now is starline.
Reloadron
Contributing Member
I can tell you what I would do. I doubt you will find any Remington brass in .308 Winchester or 7mm-08 Remington. Lately there has just been none to be had. Possibly it is going to produce loaded ammunition.
I am seeing plenty of once fired 7.62 x 54 NATO brass out there. Quality brass cleaned and deprimed. I have some sitting here and the average neck thickness on some Lake City LC - 13 and some WCC - 08 is 0.015" give or take 0.001". I also have some new Remington .308 Winchester and 7mm-08 Remington brass, new as in it was new 20 years ago. Average Neck thickness is right around 0.014" for both calibers. In the past all I have done was run the 308 brass through my 7mm-08 sizing dies. The 308 necked down to 7mm just fine and I never had to neck turn at all. Never gained enough in the necks to worry about.
I would just get a bucket of once fired 7.62 x 54 NATO brass and use it for my 308 and 7-08 loadings. You could find yourself waiting a long time for factory 7mm-08 brass. I have seen the once fired stuff at Gander Mountain, Cabela's and assorted online distributors.
Ron
- Status
