JungleSurplus
Member
- Joined
- May 21, 2019
- Messages
- 4
So a couple months ago, I bought a WASR 10. The initial inspection passed with flying colors.
extremely straight sights and gas tube, the rivets are seated correctly, and theres no mag wobble.
However a couple days ago after finally getting this rifle into a mineral spirit bath
to remove all the cosmoline, I noticed the right side of the bolt carrier groove
(where the rails sit/lock in) is extremely jagged and uneven. What the hell is this?
Here is the left side of the bolt carrier for comparison.
Is this dangerous? Is it going to blow a finger off, or start shaving away the receiver rails and getting stuck?
Im thinking of selling this rifle immediately because im sick of fretting and worrying
over this, and I dont want it to become a much larger issue in the future. Does anyone have any insight on this?
extremely straight sights and gas tube, the rivets are seated correctly, and theres no mag wobble.
However a couple days ago after finally getting this rifle into a mineral spirit bath
to remove all the cosmoline, I noticed the right side of the bolt carrier groove
(where the rails sit/lock in) is extremely jagged and uneven. What the hell is this?
Here is the left side of the bolt carrier for comparison.
Is this dangerous? Is it going to blow a finger off, or start shaving away the receiver rails and getting stuck?
Im thinking of selling this rifle immediately because im sick of fretting and worrying
over this, and I dont want it to become a much larger issue in the future. Does anyone have any insight on this?