I recently purchased a new P3AT as a carry gun. Took it to the indoor range where I bought it and every shot was a FTL/FTE with good ammo, both FMJ and JHP.
The gunsmiths there noted Smileys on the ammo and said there were burrs on numerous parts. They did some polishing with some improvement after about 150 rounds.
The next day I went to load a magazine of JHP's and the ammo would not chamber when the slide was racked.
I sent it back to Kel-Tec last week.
The workmanship of this porduct was obviously poor. I called Kel-Tec today and they said the turn-around for it should be 4-6 weeks. 4-6 weeks for a new gun which should work from the get-go seems a little ridiculous.
Any similar experiences?
The gunsmiths there noted Smileys on the ammo and said there were burrs on numerous parts. They did some polishing with some improvement after about 150 rounds.
The next day I went to load a magazine of JHP's and the ammo would not chamber when the slide was racked.
I sent it back to Kel-Tec last week.
The workmanship of this porduct was obviously poor. I called Kel-Tec today and they said the turn-around for it should be 4-6 weeks. 4-6 weeks for a new gun which should work from the get-go seems a little ridiculous.
Any similar experiences?