Ala Dan
Member in memoriam
The only bad thing I have heard of, was that the KEL-TEC P32's would not
feed the last round from the magazine; of course, causing a jam?
feed the last round from the magazine; of course, causing a jam?
KelTec P32 Breaking, Reliability Issues
- Thread starter eric.cartman
- Start date
- Status
JohnBT
Member
I've heard some of that too, but my 2nd-year model even feeds all the rounds from the 10-round mag. I only carry ball, but I've been shooting up the JHPs at the range. I really should sell the last few boxes of Silvertips instead of shooting them.
John
John
Wilson 17&26
Member
Kel-Tec sells a P-32 rimlock spacer kit for their magazines if you want to carry JHP or short ammo, for about $15. Or you can make a Flyer Wire for about 5¢. I load Cor-Bon in the pipe and top of the mag with the remainder FMJ, so no rimlock.
If a magazine wont feed the last round it could be a weak spring. Call 1-800-515-9983 Service Dept and they will send you a magazine spring free, if you think this is the case.
If a magazine wont feed the last round it could be a weak spring. Call 1-800-515-9983 Service Dept and they will send you a magazine spring free, if you think this is the case.
ArchAngelCD
Member.
I've fired a lot of ammo through my P-32 and I have never had the last round get stuck in the mag. I haven't had a problem with RimLock either but I did buy a kit just to be safe.
outdoorman63
Member
our 32 would not shoot magtech ammo and we had tons of it..it would jam,and fail to fire constantly.we switched to pmc and ahvent had any problems
- Status
