Quantcast
  1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

Kimber .22 Conversion - Extractor disassembly help

Discussion in 'Gunsmithing and Repairs' started by brandnew, Dec 14, 2008.

Thread Status:
Not open for further replies.
  1. brandnew

    brandnew Member

    Joined:
    Dec 14, 2008
    Messages:
    59
    I've done as much research as I can but I'm still at a loss for directions on how to remove the external extractor and firing pin from the .22 Kimber slide.

    I've tried over and over with the regular method of depressing the firing pin and sliding off the firing pin stop but the stop just won't budge.

    Any suggestions?
     
    Last edited: Dec 16, 2008
  2. brandnew

    brandnew Member

    Joined:
    Dec 14, 2008
    Messages:
    59
    Nobody?

    Seriously, nobody knows or has any information for me?
     
  3. artjs

    artjs Member

    Joined:
    Dec 24, 2002
    Messages:
    59
    Location:
    Wisconsin
    Quick call to Kimber Customer Service and here you go.... I needed this also, so that prompted my call to them

    Step 1:
    Remove the Elevation screw from the rear sight. NOTE Hold down on the back of the sight to ease pressure on the screw and to hold the springs underneath in place.
    Step1-RemoveElevationScrew.jpg

    Step 2:
    Lift the rear sight up, again, don't lose the springs! Here they are:
    Step2-CarefulSprings.jpg

    Step 3:
    Push the firing pin in and pry up on the firing pin stop. Yup, that's my Glock Tool :neener:
    Step3-RemoveStop.jpg

    External Extractor I didn't ask about... sorry
    Kimber's Customer Service Line: 914-964-0771 x350
     
  4. Izaak Walton

    Izaak Walton Member

    Joined:
    Nov 16, 2008
    Messages:
    106
    I did not know that, thanks!
     
Thread Status:
Not open for further replies.

Share This Page