Quantcast
  1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

kimber exlipse pro II minor challenge

Discussion in 'Handguns: Autoloaders' started by yz450, Mar 1, 2009.

Thread Status:
Not open for further replies.
  1. yz450

    yz450 Member

    Joined:
    Mar 1, 2009
    Messages:
    3
    having problems reassembling my new pro eclipse II. I cannot seem to put the slide stop in correclty. It doesn't seem to fit. Thanks in advance for any help.
     
  2. Lone_Gunman

    Lone_Gunman Member

    Joined:
    Dec 24, 2002
    Messages:
    8,056
    Location:
    United Socialist States of Obama
    Among the many Kimbers I have owned that were complete jam-o-matics, one was an Eclipse in 10mm. It also had a problem with the slide stop being hard to put back in. The problem was not with the slide stop, but with the retention spring plunger just to the right of the stop. This protruded just a little bit too far to drop the slide stop in. So I had to push in on the pring plunger with a small screw driver as I inserted the slide stop.

    It was kind of a hassle, but not the gun's biggest problem.
     
Thread Status:
Not open for further replies.

Share This Page