So, this one is the second time I take my dies out of my LCT for cleaning. I like to do so every 1000 rounds, and this weekend I hit the 2000 rounds mark. Thing is, I've had no problem taking apart the decapping&resizing die, the bullet seating die and the factory crimp die. Then I give them a thorough clean, some oiling and assemble them again. It's not that they were very dirty, but some cleaning didn't hurt them.
Problem is the powder through-expanding die. I wonder how one could disassemble this one. The expanding part seems to be locked inside the die's body. It looks like a metal sleeve that moves up and down, but it doesn't fall out of the die if you put it upside down. I've been able to clean the parts that are easily accessible, but would like to clean the rest of it.
Any ideas?. Do you think it's possible to take it apart completely?.
Inputs appreciated .
Problem is the powder through-expanding die. I wonder how one could disassemble this one. The expanding part seems to be locked inside the die's body. It looks like a metal sleeve that moves up and down, but it doesn't fall out of the die if you put it upside down. I've been able to clean the parts that are easily accessible, but would like to clean the rest of it.
Any ideas?. Do you think it's possible to take it apart completely?.
Inputs appreciated .