I had this issue. I was tightening the screw a little at a time, trying to get it to quit leaking HP-38. Finally got it to quit leaking, and started loading. I was a good ways in when I realized some of my charges didn't look quite right. Had to go back and pull about 100 rounds to double-check. Only found one other low one, should have been less trusting of "the system". So, yes, see if the drum retaining screw is too tight.Try messing with the screw that tightens it. May be too tight.
The disconnect is missing. Must have come loose during moving and got lost.Try messing with the screw that tightens it. May be too tight. What reset part?
So the drum worked just fine for 9mm and throw HP38 and BE86 just fine but it wont rotate all the way for 40cal.
Nope. Just using a normal flare die that come with the die set.Agree with ^^^^.
Make sure the die is screwed in far enough to actuate the plunger completely without causing it to “hard stop” against the housing.
Question: are you using the powder thru riser with the autodrum?
Ok. Then the suggestion I gave you is good. There’s a little more to check with the riser.Nope. Just using a normal flare die that come with the die set.
Ok. Then the suggestion I gave you is good. There’s a little more to check with the riser.