flgolfer29
Member
I apologize if this has been covered previously. This week I received the Lee Six Pack Pro progressive. After setting all the dies I was going to reload a few rounds to get a feel for it. Immediately, I noticed the primer 'stem' was not extending high enough through the shell plate to reach the shell casing to set the primer. This caused multiple failures associated with the priming system.
Does anyone know how to make the necessary adjustments to get proper primer feed positioning? If not, I intend on calling Lee customer service tomorrow. Photo added to show what I'm attempting to describe.
Thank you
Flgolfer29
Does anyone know how to make the necessary adjustments to get proper primer feed positioning? If not, I intend on calling Lee customer service tomorrow. Photo added to show what I'm attempting to describe.
Thank you
Flgolfer29
Attachments
Last edited: