Well, in all of the cast bullet loads I worked up for my XD40 cal., I never had a FTF. I found a load that was very accurate and loaded 450+ rounds and have now found that they don't feed worth a hoot. They're too short and hang up on the feed ramp. So, can I buy an inertia puller, put some "shim's" in the bottom and use this to lengthen the rounds? I would make the round too long, re-seat and re-crimp. Is this practical or do I need to just pull all of the bullets, dump powder and start over again?
Thanks, Cloudpeak
Thanks, Cloudpeak